Door reversibilityFitting a decorative door panel
Important: The components needed to Ţt the dec-
Remove the two screws which Ţx the upper hinge to
orative panel have been pre-Å¢tted on the appli-
the door.
ance.
Carefully lean the appliance on its back and remove
The brackets are secured to the panel by means of
the plastic insert (Fig. 4).
the 7 ? 3.5x13 screws supplied.
Fig. 4
Before starting to Ţt the panel, remove the large
top bracket by unscrewing the screws and adjust-
ing pins pre-Å¢tted on the appliance door. The small
bottom bracket need not be removed.
Place the appliance in the position where it is to be
built in (Fig. 6).
The appliance is Ţtted with adjustable feet; screw the
front and rear feet in or out to adjust the height of the
appliance to that of the recess.
Keeping the appliance central in the recess, slide it in
until its back touches the wall.
D447
Fig. 6
Remove the two screws which Ţx the lower hinge to
With a tape meas-
the door.
ure (or similar in-
Remove the four screws which Ţx the lower hinge toA
strument), meas-
the base of the appliance and remove the hinge itself;
ure distance (A)
==
be very careful to recover all the screws.
between the top
Remove the four screws that Ţx the upper hinge to theedge of the door
appliance and remove the hinge itself.and the top edge
of the decorative
Take the hinge removed from the upper part of the ap-
panel, placing it
pliance on the opposite side (see Fig. 5), and, using
next to the recess.
the screws removed from the lower part, Ţx it to the
D467
base of the appliance itself.
Fig. 7
Remove and reŢt the other hinge on the upper part of
the appliance on the opposite side.
Lay the panel face
Fig. 5down (Fig. 7). Posi-
tion the top bracket
Fix the two front
on the panel, mak-=
screws into the
ing sure that there
upper and lower
is an equal dis-
hinges (Fig. 5).
tance between it
=A
and the sides and
-1cm
that its distance
from the top edge
D468
is equal to distance
(A) less 1 cm.
Secure the bracket with the screws supplied.
D510
Take care not to damage the front face of the panel
Finally, check the alignment of the door and make
whilst working.
sure it closes properly.
Fig. 8
After having reversed the opening direction of the
door, discard the original plastic insert removed and Ţt
Insert the adjust-
B
the insert supplied with the appliance on the opposite
ing pins (B-Fig. 8)
side.
into their locations
in the door and
screw them in.
D532
6 |
ACEC
